Zugg Software :: View topic - Hidden Trigger, somewhere. Help Appreciated

Wanderer Joined: 07 Oct 2001 Posts: 71

I don't know exactly how to describe this oddity.

There is a trigger loop in my settings. Apparently the Pattern is Test and the command is Test .
Yeah, seems pretty simple. Though I cannot find this in my settings at all. I use the settings filter searching for Test, and versions of it. I even went through the settings visually looking for the loop causing trigger. I could not find it. I ran it through the debugger, and it shows the execution stack as "(Trigger) Test". Though like I said, I cannot find this in my settings anywhere.

Maybe others have had this same problem. If any of you already know about this problem and can offer a solution to me, I would greatly appreciate it if you would share it with me.

Thanks

MASTER Joined: 28 Nov 2000 Posts: 4817 Location: USA

1. Check your aliases too.
2. Make sure you have the settings editor set to "Show hidden" and "Show inherited" settings (View menu).
3. Individually disable all your triggers, using the green dot at the bottom of the editing window. Turn them on, one at a time, until the loop shows up. NOTE: Some triggers may enable other triggers, so the problem won't always be the last trigger you enabled -- it might be one that it enables.

LightBulb
Senior Member

Adept Joined: 09 Nov 2000 Posts: 222 Location: USA

Have you tried:

#UNTRIGGER {test}