 |
Bonzo
Newbie
Joined: 24 Jan 2003
Posts: 2
|
 Posted: Fri Jan 24, 2003 9:31 pm
Invisible rooms in a zone
|
I've been using the automapper quite a while now and created few thousand rooms with several zones. In one of the zones all the rooms just suddenly "dissapeared" - when I open the zone it's just seems empty. But if I switch to spreadsheet view then I can see all the rooms listed with descriptions and all - but not in the zone view.
Has anyone seen something like this ? |
|
|
|
|
TonDiening
GURU
Joined: 26 Jul 2001
Posts: 1958
Location: Canada
|
Posted: Fri Jan 24, 2003 10:33 pm
|
Perhaps a zoom level or current level issue?
Try a #TELEPORT to a room and see if you can re-center it?
Ton Diening |
|
|
|
|
Talahaski
Enchanter
Joined: 10 Oct 2000
Posts: 656
Location: USA
|
Posted: Fri Jan 24, 2003 11:07 pm
|
Yah, I have had this problem before also. Sometime, not sure how, the map gets off center. Usually I can find the rooms again by scrolls far down and far to the east.
TonDiening idea of the #TEleport should fix the problem, if not, try zooming out a few times and scrolling around.
Talahaski
Processor PIII 1000
Memory 265MB
Video NVIDIA 64MB
Windows XP
Zmud Version 6.50
Zmapper Version 1.14 |
|
|
|
|
Bonzo
Newbie
Joined: 24 Jan 2003
Posts: 2
|
Posted: Sun Jan 26, 2003 9:28 am
|
Actually it's none of the above - I did check the zoom, the levels (elevation) - nothing. Also it's not possible to scroll around since there are no scrollbars visible for the window.
The most frustrating is, that I can move around fine, and the current room changes in spreadsheet view, but still nothing changes in the zone view, it remains empty. Grrrr.. |
|
|
|
|
|
|
|
